|
|
- MOUNTING FLANGES for installation of the BOP into a standard (19-inch)
equipment rack. (A pair included with each BOP). Kepco Part No. 128-1282
(right), 128-1281 (left).
- SIDE COVER PLATES, for bench top use, designed to finish the two sides of
the instrument when the rack mounting flanges are not mounted. A pair included
with each BOP. Kepco Part No. 128-1285 (right), 128-1284 (left).
- REAR PROGRAMMING CONNECTOR, Kepco Model
PC-9,
30-terminal printed circuit
connector for all rear programming connections and flag signal outputs (One
included with each BOP). Model PC 16 connector is also available prewired for local control.
 SN 488 DIGITAL PROGRAMMER for remote programming of the BOP-HV via GPIB. This programmer converts decimal or BCD data to an analog voltage used to control the BOP-HV voltage channel, current channel, or both.
|
