HELP
Kepco Power Supplies
TOUR PREVIOUS NEXT
CHOOSE UTILITY
Firmware Upgrade
PS Find

Firmware Upgrade Utility

The Firmware Upgrade Utility allows the Firmware Version of selected Kepco products to be upgraded by the user at no cost. This is accomplished by downloading both the Firmware Upgrade Utility containing the application, and the Instruction Sheet that explains how to install the application and perform the upgrade.

Only the following products and Firmware Versions can be upgraded with this utility.

Product Firmware Versions
eligible for upgrade		 Notes How to Determine Firmware Version
KLP 9.00 through 9.xx
10.07 and higher		 via any digital port
  1. If the status display shows SET, tap either the CURRENT or VOLTAGE control to take the unit out of setpoint mode (status display goes from SET to blank).
  2. Using a thin tool (e.g., a paper clip), press the FUNCTION switch once, then rotate either the VOLTAGE or CURRENT control until the status display reads CNFG.
  3. Tap DC OUTPUT switch to enter the submenu, then rotate either the VOLTAGE or CURRENT control until the status display reads VERS.
    • The DC AMPERES display shows the firmware version.
    • The DC VOLTS display identifies whether the firmware is the factory shipped firmware (Pri displayed) or field updated firmware (SEC displayed).
8.01 through 8.xx via GPIB port only
KLR 10.07 and higher via any digital port

Download Now
Products • Support • Literature • Contact Us • Careers • About

KEPCO, INC. • 131-38 SANFORD AVENUE • FLUSHING, NY. 11355 U.S.A.
TEL (718) 461-7000 • FAX (718) 767-1102
www.kepcopower.com • email: hq@kepcopower.com

©Copyright 2013, Kepco Inc. All rights reserved