KEPCO LOGO - TO HOME PAGE

    HELP
Kepco Power Supplies
CHOOSE UTILITY
Firmware Upgrade
PS Find

Firmware Upgrade Utility

The Firmware Upgrade Utility allows the Firmware Version of selected Kepco products to be upgraded by the user at no cost. This is accomplished by downloading both the Firmware Upgrade Utility containing the application and Instruction Sheet that explains how to install the application and perform the upgrade.

Only the following products and Firmware Versions can be upgraded with this utility.

Product Firmware Versions
eligible for upgrade		 Notes How to Determine Firmware Version
KLP 8.01 through 8.xx via GPIB port only
  1. If the status display shows SET, tap either the CURRENT or VOLTAGE control to take the unit out of setpoint mode (status display goes from SET to blank).
  2. Using a thin tool (e.g., a paper clip), press the FUNCTION switch once, then rotate either the VOLTAGE or CURRENT control until the status display reads CNFG.
  3. Tap DC OUTPUT switch to enter the submenu, then rotate either the VOLTAGE or CURRENT control until the status display reads VERS.
    • The DC AMPERES display shows the firmware version.
    • The DC VOLTS display identifies whether the firmware is the factory shipped firmware (Pri displayed) or field updated firmware (SEC displayed).
7.01 through 7.xx via GPIB port only
6.04 through 6.xx via GPIB port only

Download Now

PS Find Utility

The PS Find Utility finds all operational Kepco power supplies connected to a LAN and then shows the pertinent addresses of the models found.

Instructions for installation and use of this utility are found in PAR. 3.3.6.2 of the KLP User Manual, available via free download

Download Now
Products • Support • Literature • Contact Us • Careers • About

KEPCO, INC. • 131-38 SANFORD AVENUE • FLUSHING, NY. 11355 U.S.A.
TEL (718) 461-7000 • FAX (718) 767-1102
www.kepcopower.com • email: hq@kepcopower.com

©Copyright 2012, Kepco Inc. All rights reserved