SERIES BOP HV
 |
TOUR
|
| MODELS |
 |
 |
| FEATURES |
| GENERAL SPECIFICATIONS |
| STATIC SPECIFICATIONS |
| DYNAMIC SPECIFICATIONS |
| OUTLINE DIMENSIONS |
| MANUALS |
| BOP-HV STATIC SPECIFICATIONS | ||||||
| INFLUENCE QUANTITY | OUTPUT EFFECTS (1) |
PREAMPLIFIER OFFSETS (6) |
REFERENCES ±10V |
|||
| VOLTAGE MODE | CURRENT MODE | ΔEio | ΔIio | |||
| Source (min.-max.) | <0.0005% | <0.0005% (5) | <5μV | <1nA | <0.0005% | |
| Load (No load - full load) | <0.0005% | <0.005% | --- | --- | <0.0005% | |
| Time (8-hour drift) | <0.01% | <0.01% | <20μV | <1nA | <0.005% | |
| Temperature, per °C | <0.01% | <0.01% | <20μV | <1nA | <0.005% | |
| Ripple and Noise (2) |
rms | <10mV | <25μA (4) | --- | --- | <10μV |
| p-p (3) | <200mV | <500μA (4) | --- | --- | <100μV | |
| (1) | Specifications are expressed as a percentage of the nominal power supply output (either voltage or current for either BOP 500M or BOP 1000M. |
| (2) | One terminal must be grounded, or connected so that the common-mode cutrent does not flow through the load. |
| (3) | Peak-to-peak ripple is measured over a 20Hz to 10MHz bandwidth. |
| (4) | For frequency components in the bandwidth of the current stabilizer. Beyond cutoff, noise will appear as a voltage component equal to the rated voltage mode noise. |
| (5) | Or 200μA, whichever is greater. |
| (6) |
The output effect can be calculated by the relationship: ΔEo = ±ΔEr (Rf/(Ri) ±ΔEio (1 + Rf/(Ri) ±ΔIio (Rf) where Rf is the feedback resistor, and Ri is the input resistor from the reference, Er. |
