Contact Kepco for details.
*** Check out Kepco's companion Series CC Current Stabilizer.
PCX 40-0.5AT Voltage Stabilizer
The Series PCX-MAT are full-range, operationally programmable power supplies with a low-offset front end and exceptional stability. They can be set or programmed to any level within their rated range, and fully loaded at any output setting.
Output voltage is controlled by a panel-mounted, 10-turn rheostat. External control is exercised by a resistance at 1000 ohms-per-volt (a built-in calibrating trimmer is used to calibrate this value) or by a control voltage delivering 0-1 mA. Control is fully operational; the power supply functions as an inverting power amplifier.
A built-in current sensing and feedback arrangement (controlled by an internal trimmer over the range 10-105%) provides protective current limiting. For precision control of current, the voltage control channel may be reconnected to sample the drop across an external current sensing resistor in the plus output lead. An external current feedback rheostat, with careful zeroing of the built-in zeroing potentiometer controls current from approximately 1mA to 100% maximum output current.
Digital control is available with a Kepco SN digital to analog converter.
Housings - Cases CA 3, CA 4, and CA 5 provide single, double or triple unit housings for Series PCX-MAT models. Rack mounting is accommodated by the RA 22-6A and RA 32 rack adapters.
Modular versions, PCX, (without meters) are available; contact Kepco for further details.
Connectors are available for connecting 12 terminal edge connector to either barrier strip or cable connector.
